Operation
101
4.2.1 Conductivity
To measure the conductivity, proceed as follows:
1 Perform the preparatory activities according to sec-
tion 4.2.
2 Immerse the conductivity measuring cell into the test
sample.
3 Press the <ì> key until appears in the status dis-
play. The conductivity value appears on the display.
4 If necessary, set the temperature by pressing
<
▲><▼> (see section 4.2, page 99).
5 Perform an AutoRead measurement according to
section 4.2.
To Next Page
Loading...
