Operation
118
*(+,, message This message appears if all 200 memory locations are full.
You have the following options:
2 Confirm with <run/enter>.
The display changes to the input of the I.D. number.
3 Enter the required I.D. number (1 ... 999) by pressing
<
▲> <▼>.
4 Confirm with <run/enter>.
The instrument changes to the measuring mode.
Store the current measured value.
The oldest measured value (memory
location 1) is overwritten by this
Press
<run/enter>
Return to the measuring mode without
storing
Press any key
Output the data storage See section 4.4.3
Delete the data storage See section 4.4.4
To Next Page
Loading...
