19
Note:
To avoid scratching the face schield, never remove or t the anti-fog lens
unless the visor unit is clean and dry.
When tting the anti-fog lens, check that neither dust nor moisture are
able to get between the two surfaces.
When removing or tting the anti-fog lens, it is always best to lay the face
schield unit on a clean, dry cloth.
Note:
In view of the strong air pressure acting when travelling with an open
face shield, we recommend riding with a closed face schield at all times to
prevent any dirt or moisture from getting inside the helmet.
Note:
Never press the locking pins out with your ngers as they may break.
Caution:
As a result of the double lens structure, there is a possibility of greater
light reection in the face schield, especially when riding at night. As a
rule, such light reection is regarded as uncritical due to the absence of
fog with this type of visor. However, if this light reection should cause
you diculties – because of particular sensitivity to it, for example – you
should refrain from using the anti-fog lens.
Caution:
If moisture is present in or has penetrated the airtight area between the
two plates, you should remove the anti-fog lens immediately in order to
prevent any interference with visibility. Do not re-t it until both plates are
completely dry (we recommend air-drying). If you should subsequently
detect any further penetration of moisture, the anti-fog lens should not be
used on any account and must be replaced.
To Next Page
Loading...
Need help?
General
