20
Safety note
Check before each journey that the face shield and sun visor mechanism are
functioning correctly and that the face shield and sun visor will provide good
visibility. Any dirt should be removed before setting o. Check the face shield
and sun visor for physical damage and cracks. Severely scratched or scued
face shields will seriously impair visibility and should be replaced before setting
o on a journey.
Caution:
Petrol, solvent and fuel vapours can cause cracking of the face shield.
Make sure that the face shield is never exposed to such vapours! Never
place the helmet on the tank of your bike.
12. SUN VISOR
SUN VISOR
The sun visor is scratch-resistant and uses a special polycarbonate to ensure
eective protection against harmful UV radiation.
Operation
The sun visor is operated by means of the slide
positioned on the left in the chin area, which is
easy to use even when wearing gloves. Moving
the slide towards the back lowers the sun visor,
moving it forwards retracts the sun visor inside
the inner helmet shell and locks it in position.
The sun visor can be operated irrespective of
the position of the face shield.
The maximum opening position of the sun visor can be set in a choice of two
latched positions using the limiter. The limiter is on the running edge of the sun
visor slider.
C. THE HELMET
To Next Page
Need help?
General
