66 67
english
FITTING THE INTERNAL LINING
Fitting the headband cushion
The semicircular guide rail stitched onto the face side is used for
fi xing the cushion, aided by the retaining strap situated in the
neck area.
1. Push the semicircular guide rail
gradually under the gaps of the
plastic rail fi xed to the inner shell.
2. Push the retaining strap of the
neck cushion gradually into the
guide gap between the inner and
outer shells.
3. Arrange the headband cushion
within the helmet ensuring that no
air channel is blocked.
Fitting the cheek comfort pads
1. Fix the cheek pad with the aid of
the red-marked plug-in device.
2. Push the retaining strap of the
cheek pad into the guide gap
between the inner and outer
shells. Begin with the lower part
of the pad.
3. Push the retaining strap with a
gentle pressure towards the shell
into the guide gap between the
inner and outer shells.
4. Repeat steps 1-3 with the other
cheek comfort pad.
C. THE HELMET
To Next Page
Loading...
