72 73
english
Refl ective areas
One aspect of the characteristic design
of the SR1 is the silver-coloured areas of
refl ective material on the rear areas of the
neck cushion and acoustic collar. These
aid the rider’s visibility in road traffi c,
particularly where visibility is poor.
On single-colour helmets (without
graphics) the SCHUBERTH name lettering
appears on the front and rear of the helmet
in refl ective foil.
Note: Keep the safety refl ective areas clean.
Note: If you intend to use the helmet in France, you are
required by law to affi x additional refl ective stickers to the
front and rear and also on the left and right-hand sides of
the helmet.
It is important to take care in fi tting a helmet. Only a helmet that
fi ts properly can provide the best possible protection in the event
of a fall or accident. Use the following steps to determine which
helmet fi ts you best:
1. Schritt: Measure the circumference of your head
2. Schritt: Determine the correct helmet size
3. Schritt: Check that the helmet size is correct
1. MEASURING YOUR HEAD SIZE
Use a fl exible tape measure to determine the size of your head.
Wrap the tape measure around your head so that it lies about 2 cm
above the eyebrows, so as to obtain the maximum circumference.
This value represents your head size in centimetres.
C. THE HELMET D. CHOOSING THE CORRECT HELMET
To Next Page
Loading...
