OPERATION
FX-318 - FX212 08/21 Operation Section 4-26
© 2021 Alamo Group Inc.
OPERATION
Tractor PRE-OPERATION Inspection
Tractor ID#_______________________ Make ___________________________
Date: ___________________________ Shift______________________________
Before conducting the inspection, make sure the tractor engine is off, all rotation
has stopped and the tractor is in park with the parking brake engaged. Make sure
the implement is resting on the ground or securely blocked up and all hydraulic
pressure has been relieved.
Operator’s Signature:__________________________________________________________________
Item
Condition at
Start of Shift
Specific Comments if
not O.K.
The flashing lights function properly (tractor & implement)
The SMV Sign is clean and visible (tractor & implement)
The tires are in good condition with proper pressure
The wheel lug bolts are tight
The tractor brakes are in good condition
The steering linkage is in good condition
There are no visible oil leaks
The hydraulic controls function properly
The ROPS or ROPS Cab is in good condition
The seatbelt is in place and in good condition
The 3-point hitch is in good condition
The drawbar pins are securely in place
The PTO master shield is in place
The engine oil level is full
The brake fluid level is full, if applicable
The power steering fluid level is full, if applicable
The fuel level is adequate
The engine coolant fluid level is full
The radiator is free of debris
The air filter is in good condition
Proper hourly greasing is done as per Operator’s Manual
DO NOT OPERATE an UNSAFE TRACTOR or IMPLEMENT
To Next Page
Loading...
