Schulz AIR PLUS - Spraying Quality and Performance Issues; Environmental Guidelines and Waste Disposal; Wastewater Disposal Practices; Solid Waste Management and Disposal

41
1. Wastewater Disposal
The presence of untreated wastewater into rivers, lakes or other water receiving bodies may adversely affect
marine life and water quality.
Schulz S.A. recommends correct treatment of wastewater through processes that ensure environmental protec-
tion and healthy quality of life in conformity with the regulatory requirements of the current legislation.
2. Disposal of Solid Waste (large parts and product packaging)
The generation of solid waste is one aspect that must be considered by the user in the use and maintenance
of the equipment. The impacts on the environment may cause signi cant changes in the quality of the soil, in
surface and underground water, and in the population’s health due to improper disposal of the discarded waste
(on streets, water receiving bodies, land lls, vacant lots, etc).
Schulz S.A. recommends that the waste resulting from the product, from its generation, use, transportation,
and treatment to its  nal disposal, be handled with care. A suitable management should consider the following
stages: quanti cation, quali cation, classi cation, reduction at source, pick-up and selective pick-up, recycling,
storage, transportation, treatment and  nal destination. Waste disposal should be done in compliance with the
requirements of local legislation in effect.
The spraying is very thick
The  nishing material features an excessive viscosity Dilute the material
The regulation is far to the right ( + ) Turn the regulator to the right (-)
The nozzle is dirty Clean it
The air  lter is with dirt excess Replace it
The container pressure is insuf cient Retighten the container
The paint or varnish jet pulses
The material is ending Re ll it
The air  lter is very dirty Replace it
Paint or varnish  ows on the
applied surface
Paint or varnish has been applied in excess Turn the regulator to the left ( - )
Excessive mist of paint or varnish
(excessive spraying)
The sprayed surface is very far Reduce the spraying distance
Paitn or varnish in the cooling
pipe
The diaphragm is dirty Clean the diaphragm
The diaphragm is damaged Replace the diaphragm
The equipment does not turn on The equipment is overheated
Remove the inlet from the
electrical grid, let it cool.
Check the air  lter
12. ENVIRONMENTAL GUIDELINES AND RECOMMENDATIONS