To Next PageTo Next Page
Need help?Do you have a question about the Schumacher SC11 and is the answer not in the manual?
General| Input Voltage | 120V AC |
|---|---|
| Input Frequency | 60Hz |
| Weight | 2.2 lbs |
| Compatibility | 12V batteries |
| Output Voltage | 12V |
| Battery Type | Lead Acid, AGM, Gel |
| Cable Length | 6 ft |
| Safety Features | Reverse polarity protection |
Covers handling, connections, maintenance, and electrical safety for the charger.
Highlights danger of explosive gases around batteries and necessary precautions.
Informs about chemicals known to cause cancer and birth defects.
Precautions for working near batteries, including PPE and avoiding sparks.
Specifies battery types (Lead-Acid, GEL, AGM) and voltage limits for use.
Explicitly prohibits charging a frozen battery to prevent damage or injury.
Steps for removing battery, ensuring ventilation, cleaning terminals, and setting voltage.
Guidance on positioning the charger away from battery and ensuring ventilation.
Disconnecting clips with charger off and unplugged from AC outlet.
Instructions for attaching clips to battery and chassis.
Detailed steps for connecting the charger clamps to a battery in a vehicle.
Procedure for connecting charger clips to a battery outside the vehicle.
Recommendations for using extension cords, including wire gauge and condition.
Description of POWER, % CHARGE/BOOST, CLAMPS REVERSED, and BAD BATTERY LEDs.
Details on 6<>2A CHARGE, 20A BOOST, and 80A ENGINE START modes.
Explanation of STANDARD, AGM, and GEL battery type selections.
Step-by-step guide for charging a battery while it remains installed in the vehicle.
Step-by-step guide for charging a battery that has been removed from the vehicle.
Explains how the charger switches to maintain mode after charging is complete.
Table showing estimated charging times for various battery applications and sizes.
Information on what happens when charging aborts or desulfation is unsuccessful.
Procedure and safety warnings for using the charger to jump-start an engine.
Addresses why clamps may not spark and troubleshooting for no power.
Troubleshooting for unlit LEDs, bad battery indicator, and flashing LEDs.
Guidelines for cleaning clamps, the charger case, and proper storage.
Diagnosing issues when the BAD BATTERY LED is lit or voltage drops.
Troubleshooting short/no start cycles, loose connections, and charger overheating.
Details on the charger's electrical input and DC output ratings.
Information on contacting customer service for troubleshooting and repair assistance.
Details on the two-year limited warranty, exclusions, and purchaser obligations.
