Maintenance
05.00 | ELB | Montage- und Betriebsanleitung | en | GAS 376437
97
WARNING
For safety reasons, maintenance work may only be carried out
on a unit which has been switched off and depressurized.
Certain maintenance work however (e.g. setting the operating
pressure) requires a system that is ready to operate.
• Only carry out maintenance work which is described in this
document or for person who have been trained and
authorized.
NOTE
The maintenance work can either be carried out by the
customer, the person responsible for the technical care of the
unit, or by the manufacturer's service technicians.
If the customer is responsible for performing maintenance work
on the unit, we recommend participating in a training course at
the manufacturer's. In this training course you will be instructed in
the correct way to do maintenance work.
7.1 Care
CAUTION
The guide system is not sealed. Contamination must be avoided
at any cost since this will damage the guide.
7.2 Checks
Ø Regularly check all electrical connections for firm seating.
Ø Regularly check cable for damage. Shut down the automated
system in the event of defects and replace the cables.
To Next Page
Loading...
