Schweigen Hi Flow VX120 - Minimum Mounting Height; Avoidance of Back Flow; Safety of Children; Replacement of Supply Cord

Page 6
2. Your Safety
Minimum Mounting Height
This fan unit is intended for mounting at a minimum height of 2.1 metres (measured to the lower part
of the fan impeller) above a oor or the ground.
Avoidance of Back Flow
Care should be taken to avoid the back ow of gases into the room from the open ue of gas or
other open re appliances.
Safety of Children
This appliance is not intended for use by children; or inrm persons with reduced physical, sensory or
mental capabilities; or people with lack of experience and/or knowledge, unless given supervision
or instruction concerning the use of the appliance by a qualied person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance; it is not a toy.
Replacement of supply cord
If the supply cord is damaged, it must be replaced by a service agent or suitably qualied person in
order to avoid a hazard.
Why Flexi-duct
Someinternetsitesstronglyrecommendtheuseofrigidductingoverfullyexibleducting.Thismay
well be the case with conventional rangehoods with internal motor rangehood.
Schweigen’s unique Hi Flow system works in the opposite way to conventional rangehoods, pulling
air through the hood and acoustically-matched ducting which results in almost silent, high volume
ow. Using a completely rigid or semi-rigid ducting system creates an undesirable ‘organ-pipe’ sound
effect similar to that of a didgeridoo, where noise is produced at one end then amplied at the
other.
The Hi Flow system eliminates any produced noise by externalising it.
Warning: Installation without the use of at least the minimum recommended length of acoustically
matched exi-ducting in the system will void performance expectations. Any installation problem
must be reported to Schweigen. Call outs relating to incorrect installation will result in a service fee
direct to the customer. Schweigen takes no responsibility for problems caused by faulty installation
and may void warranty. A preferred installer list can be obtained from Schweigen website
www.schweigen.com.au or call 1300 881 693.