_n_. _RH Section_
Page 11
Danger
Always switch o and disconnect the power cord before replacing any light bulbs. Failure
to do so may cause serious injury. Please be aware that the light bulb will retain heat for
a short period of time after being switched o.
5. Cleaning & Maintenance
Replacing the LED Strip Light
Step 1
Remove the lters from
the rangehood.
Step 2
Disconnect the LED strip light
cord by pushing the plastic clips
in and puling the cord.
Step 3
Push the 4 clips in and gently
push down. The light will then
come out.
Step 4
Insert the new light by pushing
into the cavity until the light clips
in. Plug in the strip light cord
Step 5
Replace the lters
to the rangehood
To Next Page
Loading...
