12
■ Daily maintenance
Dry the Schwinn Evolution Bike after each use to
remove sweat and moisture. Wipe your Schwinn
Evolution Bike regularly with a mild, non-abrasive
cleaner and water solution. Rinse to remove
detergent residue and then dry.
IMPORTANT! To avoid damaging the finish on your
Schwinn Evolution Bike, never use a petroleum-
based solvent when cleaning.
■ Chain adjustment
The chain on your Schwinn Evolution Bike has been
factory set and lubricated. It should not require any
immediate attention. Over time however you may
need to make minor tension adjustments.
1. With an adjustable wrench, loosen the two bolts
on either side of the flywheel. (Fig. 11)
2. Tighten the two smaller nuts which go through
the frame tube evenly by turning clockwise until
there is approximately 3/16” of slack in the chain
(Fig. 12).
3. Tighten the two larger nuts on the sides of the
flywheel (Fig. 11).
THE SCHWINN EVOLUTION BIKE
MAINTENANCE
To Next Page
Loading...
