Page 13
Preventive maintenance (PM) is a schedule of planned maintenance actions aimed at the prevention
of failures. PM is the best way to preserve and enhance equipment reliability by keeping key com-
ponents clean and free of debris. PM activities may include cleaning, vacuuming, visual inspections
of key components, lubrication, etc. The better your PM program is, the more dramatically you can
increase the life of your product and signicantly reduce equipment failures.
To keep it in top condition, perform regular daily, weekly, and monthly preventative maintenance
routines outlined below. It is the sole responsibility of the owner of this equipment to ensure that
regular maintenance is performed. Worn or damaged parts must be replaced immediately, or the
equipment removed from service until the repair is made.
Maintenance Schedule
Some types of PM need to be performed more often than others. The frequency of PM depends a
great deal on the use and environment of the unit. Core has a baseline of procedures that should
be performed at pre-determined intervals as shown below, but it is imperative to understand that
this is a baseline and PM schedules should be adapted to the environment and usage that the unit
receives.
Daily Weekly Monthly Bi-Annually
General Maintenance
Inspect for loose assemblies, nuts or bolts and tighten as
necessary.
X
Remove and replace any components that are damaged or
deemed unsafe.
X
Inspect Pedal Bolts
1
X
Check ywheel alignment, realign ywheel nuts as necessary
X
Inspect seat for wear
X
Inspect Pedals
2
X
Tighten Seat Hardware
X
Inspect and tighten pedal toe clips and shoe straps
X
Inspect leveling feet
X
Clean and seal frame
3
X
Lubricate horizontal and vertical seat sliders
4
X
Inspect welds for any signs of cracking
X
PREVENTATIVE MAINTENANCE
To Next Page
Loading...
