Page 14
Daily Weekly Monthly Bi-Annually
Cleaning
Wipe down and clean Bike and Frame
X
1 - Verify that pedal bolts are tight after the rst 10 hours of use and every 100 hours of use thereafter. Pedal-to-crank-arm bolt torque is 33-37 ft-lbs
2 - Excessive side-to-side movement or bearing resistance indicates the pedals need to be replaced.
3 - Use water with a non-abrasive soap, car wash soap, or bike cleaner soap to clean. Wipe with water and dry. Seal with wax or bike polish.
4 - Dry lm lubricant with PTFE or wet lm lubricant with PTFE may be used. These products can be purchased online via pike companies, at bike shops, and at some hard-
ware stores. Apply a layer using a cloth to clean up excess.
Preventive Maintenance Cautions
• While maintaining equipment you will want to avoid spraying any liquids directly onto any surface of the unit.
Always spray cleaning solutions onto a clean towel rst then wipe the unit.
• Danger: Pedals that have not been tested and qualied by Schwinn should never be used on Schwinn
bikes. Unqualied pedals can lead to pedal failure and serious injury to the rider.
To Next Page
Loading...
