Protective Earth Conductor
The mains supply must include a correctly installed protective earth conductor. The protective earth conductor
must be installed or checked by a qualified electrician before the system is connected.
WARNING! Electrical Shock Hazard. Do not intentionally interrupt the protective
earth conductor. Any interruption of the protective earth conductor will create an
electrical shock hazard.
Environmental Precautions
Use qualified personnel for the installation of electrical mains, heating, ventilation, and plumbing supplies and
fixtures. Make sure that all of the installations comply with local bylaws and biohazard regulations. For more
information about the required environmental conditions for the system, refer to the Site Planning Guide.
WARNING! Biohazard. For biohazardous material use, always comply with local
regulations for hazard assessment, control, and handling. This system or any part is
not intended to act as a biological containment.
Electromagnetic Environment
CAUTION: Potential Wrong Result. Do not use this device in close proximity to sources of
strong electromagnetic (EMC) radiation (for example, unshielded intentional RF sources),
as EMC radiation might interfere with the proper operation and cause a wrong result.
Make sure that a compatible electromagnetic environment for the equipment can be maintained so that the device
will perform as intended.
Decommissioning and Disposal
Before decommissioning, decontaminate the system following local regulations.
When removing the system from service, separate and recycle different materials according to national and local
environmental regulations.
Do not dispose of system components or subassemblies, including computer parts, as unsorted municipal waste.
Follow local municapal waste ordinances for proper disposal provisions to reduce the environmental impact of
WEEE (waste, electrical and electronic equipment). To safely dispose of this equipment, contact a local Customer
Service office for complimentary equipment pickup and recycling.
Operator GuideExionLC™ PDA Detector
RUO-IDV-05-1842-B6 of 47
Introduction