Clean the Module Surfaces
Required Materials
• Dry, soft rags, or tissue paper
• For persistent stains
• Diluted, neutral detergent
• Water
1. Wipe the module surfaces with the rag or tissue paper.
2. If the stains persist, follow these steps:
a. Moisten a rag in the diluted, neutral detergent and then wring it dry.
b. Wipe the module surfaces, scrubbing as necessary to remove the stains.
c. Moisten a rag in water and then wring it dry.
d. Wipe the module surfaces.
e. Dry with a dry rag.
CAUTION: Potential System Damage. Do not allow spilled water to remain on the
instrument surface and do not use alcohol or thinner-type solvents to clean the surfaces.
Doing so can cause rusting and discoloration.
ExionLC™ PDA DetectorOperator Guide
33 of 47RUO-IDV-05-1842-B
Service and Maintenance Information
To Next Page