Scooterpac Ignite | User Manual 27
7.12 USB Ch a r g ing Ports
The Ignite is equipped with USB Charging Ports on the right-hand side of the tiller
column.
The two USB ports provide different power outputs. USB Port 1 is located next to the
LED light and USB Port 2 can be found on right hand side.
Smaller devices will perform best in the left port (Port 1), while newer devices will work
better in the right port (Port 2).
The power available from each port:
• USB Port 1: 5v – 0.5amp
Suitable for older devices manufactured prior to 2015.
• USB Port 2: 5v – 2.0amp
Suitable for newer devices, manufactured after 2015 – this will provide a higher
charging rate.
TOP TIP – If unsure, please check the user manual of the device you would like to
power to confirm required charging rate.
Figure 13 - USB charge ports
To Next Page
Loading...
