Scooterpac Ignite | User Manual 29
7.14 Ch a r g e P o rt
Charging the Ignite can be completed by using the charge port on the tiller.
The port is located on the tiller column on the right-hand side. To charge the vehicle,
simply connect the supplied charge cable to the port.
When the Ignite is in charge mode it will not enter drive mode.
TOP TIP – For best practice, please ensure to charge your batteries after each use.
You cannot overcharge them as your charger will automatically cut-off when it
detects they are full.
If there are long periods where you decide not to use your scooter, we recommend
that batteries are charged at least once a fortnight.
This will ensure they remain healthy and are ready for regular usage.
Figure 15 – Tiller mounted
charge port
To Next Page
Loading...
