Scooterpac Invader | User Manual 8
When the speed override key ignition is turned ON, the following will happen on the 3 Speed Switch (see Section 8 –
Handlebar Controls Guide):
1. When the above is turned ON the override function will be enabled. This will allow the user to achieve speeds of
up to 16mph. This speed can be achieved in ALL speed switch modes. This is for off-road use ONLY. Our terms
and conditions for off-road use can be found in the Product Disclaimer, enclosed in the Welcome Pack.
When the speed override key ignition is turned OFF, the user can only achieve a maximum of 8mph. The 3 Speed Switch
settings become:
1. Setting 1 – Pavement speed – The user will be able to achieve a maximum of 4mph.
2. Setting 2 – Safety switch – This switch does not do anything when the speed override ignition is OFF, and acts as
a safety buffer between the 4mph and 8mph speed modes.
3. Setting 3 – Road speed – The user will be able to reach a maximum of 8mph, for on the road use.
To Next Page
Loading...
