Scosche FD5000SW - Wiring Details; Wiring Notes and Color Codes

WIRE COLOR CODES:
White = Leftfrontpositive(LF+)
White/Black = Leftfrontnegative(LF-)
Green = Leftrearpositive(LR+)
Green/Black = Leftrearnegative(LR-)
Gray = Rightfrontpositive(RF+)
Gray/Black = Rightfrontnegative(RF-)
Violet = Rightrearpositive(RR+)
Violet/Black = Rightrearnegative(RR-)
Violet/White = Reversetrigger(-)
Yellow = +12voltbatteryconstant
Red = +12voltaccessoryswitched
  (DATA-controlled/R.A.P.)
Black = Chassisground(-12V)
Orange = +12Villumination
WIRING NOTES
1. TheRed+12VswitchedaccessorywirecomingfromtheFD5000SW interface is rated at 10 amps for
usewithasingleAftermarketstereo.Connectingadditionalaccessoriestothis+12Vpowersourcecan
cause damage to the FD5000SW module.
2. There are wires connected ONLY between the FD5000SW interface plug and the vehicle connectors
(under the insulating tape). Do not make any connections or cuts to these wires.
3. Ifyourstereodoesnotcontainan“Orange”illuminationwire,thentheorangewirewillnotbeused.
Tape or cap all unused wires to prevent short circuits
6
ThecolorcodesusedonthisinterfaceharnessconformtothestandardssetbytheE.I.A.(Electronics
IndustryAssociation).Theymaydifferfromthewiringcodesfoundonyourcarstereo.Alwaysreferto
your stereo owners manual for wiring details about your particular car stereo.