HID312, HID525 and HID540
Installation and User’s Manual
October 2014
Page 19
14. Push the Clean button. The unit will operate the
auger motor for 30 minutes and then stop.
Note: Stop at any time by pushing the On/Off button.
15. Disconnect unit from electrical power.
16. Drain the scale remover solution from the water
system by pulling the reservoir drain hose from its
plug and return it to the plug when drained.
17. Pour 24 ounces of clean, potable water into the
reservoir.
18. Drain the water from the water system by pulling
the reservoir drain hose from its plug and return it
to the plug when drained.
19. Mix a solution of 4 ounces of ice machine scale
remover and 16 ounces of potable water. Use
this scale remover solution to washout the water
reservoir cover, ice discharge chute, ice chute
cover, ice delivery chute, storage bin cover and
inside of the ice storage bin. Also wash the sink /
drip tray and grill with this solution. Pour half down
the bin drain and the rest into the sink / drip tray to
ush out their drains.
Sanitize now.
20. Mix a 2 gallon solution of sanitizer. A
recommended sanitizer solution is one 2 oz.
packet of Stera Sheen Green Label and 2 gallons
of warm (95
o
to 105
o
F.) potable water, or an
equivalent sanitizer at a concentration of 100 ppm.
21. Pour the sanitizer solution into the reservoir until it
is full.
22. Remove the ice outlet cover and ice dispenser
agitator from the bin. Wash them with the sanitizer
solution.
23. Thoroughly wash all inside surfaces of the ice
storage bin, ice chute cover, ice discharge chute
and ice dispense chute with the sanitizer solution.
24. Wash the sink / drip tray and grill with the sanitizer
solution. Pour remaining sanitizer into the bin and
sink.
25. Drain sanitizer from ice making system by pulling
reservoir drain hose from plug and return hose to
plug when drained.
26. Loosen thumb screw holding water reservoir to
post and lower the water reservoir to the top of the
slot, retighten thumb screw.
27. Return the ice chute cover and agitator to the
inside of the storage bin. Secure with the original
fasteners.
28. Return the ice discharge chute, water reservoir
cover, and ice dispense chute to their original
positions and secure them with their original
fasteners.
29. Reconnect water and electrical power to the
machine.
30. Push the On / Off button to restart ice making.
31. Operate machine for 5 minutes and then push the
On / Off button to stop ice making.
32. Discard the ice and return the dispense bin cover
to the machine and secure with the original
screws.
33. Push the On / Off button to resume ice making.
34. Return all panels to their normal positions and
secure with the original screws.
Other Maintenance
The auger in the ice making system is centered by
bearings at the top and bottom. It is also sealed from
leaking by a water seal at the bottom.
The bearings
are permanently
lubricated and need no
maintenance. The can
be visually checked for
obvious wear or damage
but there is no need to
add lubrication.
Auger motor bearings
and the gear reducer
are also permanently
lubricated and need no
maintenance.
The bottom of the ice making system should be
checked for water leaks. Water draining from
the bottom is an indication of a water seal leak.
Immediate repair is required when a water seal leak is
discovered.
Caution: Moving
parts hazard.
Do not touch the
rotating shaft at any
time.
Bearing
Rotating Shaft -
Do NOT Touch
To Next Page
Loading...
