REPEAT playback
Listen to iPod
Install the iPod universal dock adapter
1. Select the iPod universal dock adaptor fitting to your iPod
model, from the next table. The adapter No is marked at
the back of the adapter.
2. Install the adapter with two tabs facing the front, by pushing
it down in the universal dock at the main unit top.
3. To remove the adapter, press at the back of the adapter and pull it up.
1. With correct iPod universal dock adapter installed, gently dock the iPod
(without the protective cover) into the unit universal dock.
2. When docked, Internal iPod battery will be charged until it is fully charged.
3. In ON mode, press SOURCE button to select “IPOD”.
You can use the remote control to control iPod functions:
4. Press MENU/ MEMO button on the remote control to iPod
access the iPod menu.
5. Press / button to select a function.
6. Press ENTER button to confirm the function.
7. You can press MENU/ MEMO button to return to previous menu.
8. When a song is selected, press button to playback the music.
9. During playback, press / to select next or previous song. You can also press
MENU/ MEMO button to display the menu to select other functions.
10.Alternately, you can control your iPod directly for playback.
Note: 1. Only the universal dock adapter Nos. 1 to 7 are supplied with this unit.
Adapter Nos 8 to 11 should be supplied with your iPod model and they can be used
with this universal dock.
2. Ensure that you use the universal dock adapter corresponding to your iPod in order
to ensure that it is installed in a stable way and that the electrical contact is good
GB-10
PLAYING iPod AND CHARGING INTERNAL iPod BATTERY
To Next Page
Loading...
Need help?
General