EN ::: 24
EN
> MOUNTING THE MECHANICAL END STOPS TO THE
RACKS
fastening b
Correct installation as seen from above.
fastening a
1) Open the gate completely
2) Position the rst end stop on the rack so as to
engage the switch. (Spring gure a)
3) Screw the end stop to the rack using the
counter sunk screws (fastening b)
4) Close the gate completely
5) Position the second end stop to the gate so
as to engage the switch. (Spring gure a)
6) Screw the end stop to the rack using the
counter sunk screws (fastening b)
At this stage of the installation the
motor is not connected and is
disengaged.
To Next Page
Loading...
