2. Moving and resetting the camera
When the camera is all set up, you can unplug the
camera and move to another room. As long as the
camera is placed within the same network, it will
automatically re-connect to the router.
- You will need to reset and repeat all above
installation steps only for the following:
a. Moving the camera to another network location.
b. When you change the router or router settings
such as WiFi PW, wireless encryption mode etc.
c. If you forget the camera PW.
d. Camera malfunctions.
3. Resetting: While the camera is ON, hold down
the reset button for about 15 sec. and release.
Wait about a minute. When LED starts to double
blink again, reset is complete.
To Next Page
Loading...