SDL Atlas Vortex M6 - Setup Procedures; Removing Shipping Brace and Plug

__________________ Vortex M6
5
3.4Setup

EquipmentRequiredforInstallation

NOTE:IftheVortexM6isdeliveredonacoldday(belowfreezing), or is stored in an
unheated room or area during the cold months, do not attempt to operate it until the
VortexM6hashadachancetowarmup.


Theproperorderofstepsmustbefollowedtoensurecorrectinstallation.Refertothelist
belowwheninstallingyourinstrument.

3.4.1Removetheshippingbraceandshippingplug.

3.4.1.1 Removetheshippingbracefromunderthelid.

3.4.1.2 The shipping plug will be released from the base of the
instrumentwhenremovingthecardboardbase.

