SDL Atlas Vortex M6 - Water Supply Requirements and Warnings; Hose Coupling and Faucet Requirements; Water Temperature and Pressure Safety

__________________ Vortex M6
7
NOTE:  Water supply faucets must fit standard 3/4 inch [19 mm] femalegardenhose
couplings.DONOTUSESLIP‐ONORCLAMP‐ONCONNECTIONS.

NOTE:Watersupplyfaucetsshouldbereadilyaccessibletopermitturningthemoffwhen
theVortexM6isnotbeingused.



NOTE:Waterpressuremustbeaminimumof20toamaximumof120poundspersquare
inch[minimumof138toamaximumof827kPa]staticpressuremeasuredatthefaucet.

NOTE:Waterpressureunder20poundspersquareinch[138kPa]willcauseanextended
filltimeintheVortexM6

3.4.3.1 Turn on the water supply faucets and flush the lines for
approximately two minutes to remove any foreign materials
that could clog the screens in the water mixing valve. This is
especiallyimportantwheninstallingyourVortexM6inanewly
constructedorrenovatedbuilding.Build‐upmayhaveoccurred
duringconstruction.

3.4.3.2 Removethetwoplainrubberwashersandtwofilterscreens
fromtheaccessoriesbag.

3.4.3.3 Install them into each end of the fill hoses as shown. The
screenmustbefacingoutward.

3.4.3.4 Screw hose couplings with the filter screens onto the water
faucetsuntiltheyarefinger‐tight.Usetheredcolor‐coded
hose for the hot water connection and the blue color‐coded
hoseforthecoldwaterconnection.

3.4.3.5 Then,usingapliers,screwapproximately1/4turn.

3.4.3.6 Screwhosecouplingsfromotherendofhosesontothewater
mixing valve until they are finger‐tight. Make sure the red
color‐codedhosefromthehotwaterfaucetgoestothewater
mixingvalvemarked“H”and the blue color‐coded hosefrom
thecoldfaucetgoestothevalvemarked“C”.

3.4.3.7 Then,usingapliers,screwapproximately1/4turn.