Operation & Maintenance Manual──LG918 Wheel Loader
29
flammable material, fire may occur. Be aware of the
flammable materials such as lipin, cotton, papers, dry
grass, chemicals and oily or oiled rags.
6.5 Don’t Get Close to High Voltage Wire
Do not touch the aerial electric wire. Electroshock
may result in even when close to a high voltage wire.
The distance between the loader and the electric wire
should be:
z At least 2m (6.5ft) at low voltage condition.
z At least 4m (13ft) at 40KV high voltage condition
(electric wire is generally supported by fixed
insulator).
z At least 6m (20ft) at 40KV high voltage condition (electric wire is generally supported by
hanging insulator).
The vertical distance between loader and the overhead electric wire should be:
z At least 2m (6.5ft) at low voltage condition.
z At least 4m (13ft) at high voltage condition.
To prevent an accident, please do as follows:
z First ask the electricity company for the voltage. Check the validity of action according to the
relevent rules when the machine may touch the electric cables.
z Wear rubber shoes and rubber gloves. Lay a leather cushion over the operator’s shoes. Be sure no
part of your body can touch the metal bottom.
z Assign a signal warner, who can give a warning when the machine gets too close to electric
cables.
z Never leave the operator cab, never move and do not touch any part of the machine until the
people who are on the ground cut off the electricity once the machine touches the wire.
z When operating near high-voltage cables, make sure other persons are far from the machine.
To Next Page
Loading...
Need help?
General
