Operation & Maintenance Manual──LG918 Wheel Loader
41
dirt and oil can erode a tire. No light, heat insulation or ventilation are needed for storage. Cover
the tires with a canvas, plastic or other anti-dust cloth. The wrong storage method can greatly
reduce the quality and life of tires.
z Stand the tire on level ground and use a wedge to lock it to prevent it falling down. The quality
may be reduced if the tire is laid on its side. The tire should be rotated (90°) once per month at
least.
z Please stand aside if a tire starts to fall down. Never try to hold a tire since the tires for
engineering mechanisms are generally very heavy, and you may be seriously hurt.
8.20 Waste Materials
Do as follows to prevent pollution:
z Never dump waste oil under ground or into the river.
z Contain the oil vented from the machine in a container; never dump the oil directly onto the
ground.
z Obey the relative rules and laws when dealing with harmful materials such as grease, fuel,
coolant, solvent, filter and storage battery.
9 SAFETY TRANSPORTATION
9.1 Assemble and Disassemble the Machine
z Keep the engine speed low during loading and unloading the machine.
z Load and unload machine on level ground and remain at a safe distance off the road.
z Secure the tires well during loading and unloading the machine to make sure it will not move. Put
a cushion under the gangway.
z Slope boards should be strong enough with sufficient length and width to form a safe slope. The
angle with the ground should not be larger than 15°. Keep a safe distance between slope board
and board, board and machine.
z Make sure the height of the two sides of the board is uniform to ensure firm orientation.
z Keep the board surface clean, free of lubricant, oil, ice and loose materials. Clean the dirt off the
tires.
z Never turn around on the slope board. If it is necessary, turn outside the board and then drive
To Next Page
Loading...
Need help?
General
