SE Electronics sE4400 - Safety, Maintenance, and Warnings; General Product Safety; Equipment Risk of Damage; Technical Specifications

4
Safety and maintenance
Warning
The product may contain small, detachable parts, which may cause choking, personal
injury, or death, especially in children. Please exercise care in the use and handling of
small parts and keep them away from children under four years of age.
• This product is safe under normal and reasonably foreseeable operating conditions.
• Do not open or modify the product.
• The product must be returned to the manufacturer or destinated vendors for any service or repair.
• Do not disassemble or attempt to service this product.
• This is not a children’s product and is not intended to be used by children under 14 years old.
Risk of damage
Please make sure that any piece of equipment to which your sE product will be
connected fulfills the safety regulations enforced in your country and is fitted with a
ground lead.
Technical Specifications
sE4400 / T2
sE4100 / T1
Capsule
Hand-crafted 1“ true condenser capsule
Polar patterns
Cardioid, Hypercardioid, Omni-directional,
Figure-8
Cardioid
Frequency range
20 – 20,000 Hz
Sensitivity
25 mV/Pa (-32 dBV)
Max. SPL (0.5% THD)
(0/10/20 dB Attenuation pad)
137 / 147 / 157 dB
SPL
Equivalent noise level
13 dB(A)
9 dB(A)
Dynamic range
(0/10/20 dB Attenuation pad)
124 / 134 / 144 dB
128 / 138 / 148 dB
Signal-to-noise ratio
81 dB
85 dB
Low cut filter
40 / 80 Hz, 6 dB/Oct, switchable
80 / 160 Hz, 6 dB/Oct, switchable
Attenuation pad
10 / 20 dB, switchable
Powering
48 Volts according to IEC 61938
Electrical Impedance
22 Ohms
125 Ohms
Recommended load impedance
>1k Ohms
Current consumption
3.7 mA
3.0 mA
Connectivity
3-pin male XLR connector