EasyManuals Logo

Sea-doo 230 Series User Manual

Sea-doo 230 Series
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #152 background imageLoading...
Page #152 background image
MONITORING SYSTEM
A system monitors the electronic components of the EMS (engine management
system) and other components of the electrical system. When a fault occurs,
it sends visual messages through the information center and/or audible signals
through a beeper to inform you of a particular condition.
A fault code may also be recorded.
When a minor or transient fault occurs, the faultmessage and beeper will cease au-
tomatically if the condition that caused the fault does not exist anymore.
Releasing the throttle and letting the engine return to idle speed may allow normal
operation to come back. If this does not work, try removing and reinstalling the
tether cord on the engine cut-off switch.
The electronic system will react differently depending on the fault type. In severe
failure, the engine may not be allowed to be started. In other cases, the engine will
operate in limp home mode (reduced speed).
When a fault occurs, see an authorized Sea-Doo Boats dealer as soon as possible
for inspection.
Beeper Code Information
BEEPER CODE DESCRIPTION
Shifter lever not in Neutral position. Move shifter
to Neutral.
1 long beep while installing
tether cord on engine cut-off
switch or when pressing
Start/Stop button
Unable to read key (wrong installation or dirty key).
Remove tether cord, make sure it's clean and
reinstall.
4 short beeps while pressing
Start/Stop button with tether
cord installed
Shifter is not in Neutral. Move shifter to Neutral.
1 short beep while moving
shifter to neutral
Confirms that shifter is now in Neutral.
4 short beeps at different interval
Tether cord has been left on its post without the
engine running. Remove tether cord to prevent
battery discharge.
High engine coolant temperature. Refer to
ENGINE OVERHEATING
in
TROUBLESHOOTING
GUIDELINES
High exhaust temperature. Refer to
ENGINE
OVERHEATING
in
TROUBLESHOOTING
GUIDELINES
.
Continuous beep
Low or high engine oil pressure. Check oil level as
soon as possible. If level good, discontinue use an
contact an authorized Sea-Doo Boats dealer.
NOTICE
If the monitoring beeper emits a continuous beep, stop engine as
soon as possible.
150
______________

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sea-doo 230 Series and is the answer not in the manual?

Sea-doo 230 Series Specifications

General IconGeneral
BrandSea-doo
Model230 Series
CategoryBoat
LanguageEnglish

Related product manuals