Sea Eagle Boats PackFish7 - Patching Tips

12
Apply patch to the boat.
Smooth with finger or a
smoothing tool such as a
spoon, handle of a utility
knife, or screwdriver. For
best results, heat patch
with a hair dryer 10-20
seconds and smooth with
tool.
Patching Tips:
• For immediate use, allow 30 minutes to cure and
inate ¾ full
• Chamber must be deated or air will make a path
through the glue
• Do not apply the patch while glue is wet
• For larger repairs, overlap the damaged area by about
½” on each side
• Trim the patch material to size, the larger the patch
the harder it is to seal
• Covering a leaking patch with a larger patch does not
work. Remove old patch with hairdryer.
• Covering a seam with a patch will not work
• Internal sealants and spray-on waterproong are not
recommended
• Alcohol, acetone (nail polish remover), toluene and
MEK solvents can be used
• Sanding is not recommended
• Clamps and weights are not needed
PackFish7™ | Trouble Shooting: Repairs
Cut patch along the outline
with scissors.
Pro Tip: Trace the outline
of the penny on masking
tape and cut with a utility
knife. Apply tape to the
boat instead of tracing on
the boat.
Trace the outline of a
penny on the patch
material and on the boat.
If a larger patch is needed,
use a larger item as a
template.