Sea Eagle Boats PackFish7 - Deluxe Inflatable Seat; Oar Assembly

7
PackFish7™ | Inflation & Assembly
Deluxe Inflatable Seat
Seat has two cushion
bladders inside the cover
and requires two valves.
Seat straps clip to rings in
seat base. Seat base has
zipper for removing or
adjusting bladders if
needed.
Stretch retainer ring over
the valve base. Retainer
ring fits in a groove in
valve base.
If ring is too tight to fit:
stretch it, or heat ring
under warm water or with
a hairdryer to soften it.
Unscrew the cap. Screw
valve into base. Tighten
valve rmly so air does not
escape when sitting on
seat!
Insert wide push-in or
screw-in adapter into
hose. Push and turn
adapter to lock it into
hose.
Push or screw valve
adapter into valve. Inate
seat until comfortably
rm. The back bladder
can be fully inated, or
partially deated to give
more legroom.
Tighten valve caps
securely to avoid
deflation.
Oars
Each oar has a shaft,
retainer ring, and blade.
Left side oar has the Sea
Eagle logo top left. Logo
is top right on right side
oar. Retainer ring is a 2 ¼”
black rubber disk.
Slide retainer ring onto
shaft approximately 18”
from handle end.
Insert shaft into oarlock
up to retainer ring.
Pump until firm.
DO NOT over inflate the
tubes. Stop once you
can press your thumb
about 1/2” into the
tubes.