B
Bryan FloresAug 15, 2025
What to do if the SEA GATE 1 DG R1 gate is stopped by an obstacle?
- JJason NavarroAug 15, 2025
If the SEA Control Unit gate is stopped by an obstacle, the solution is to remove the obstacle.
To Next PageTo Next PageWhat to do if the SEA GATE 1 DG R1 gate is stopped by an obstacle?
If the SEA Control Unit gate is stopped by an obstacle, the solution is to remove the obstacle.
What to do if there is an ammeter alarm on my SEA GATE 1 DG R1 Control Unit?
If the SEA Control Unit experiences an ammeter alarm, verify whether the alarm has been triggered and, if necessary, increase the torque parameter.
What to do if the stop contact is open on my SEA Control Unit?
If the stop contact is open on your SEA Control Unit, check the jumpers or the connected devices and the signals indicated on the warning lamp.
What to do if the edge contact is open on my SEA GATE 1 DG R1 Control Unit?
If the edge contact is open on your SEA Control Unit, check the jumpers or the connected devices and the signals indicated on the warning lamp.
What to do if the motor is in released position in my SEA GATE 1 DG R1 Control Unit?
If the SEA Control Unit motor is in the released position, re-lock the motor.
What to do if there is a programming error on a SEA GATE 1 DG R1?
If the SEA Control Unit has a programming error, repeat the programming.
What to do if the SEA Control Unit gate opens but doesn’t close?
If the gate opens but doesn’t close, it could be due to several reasons: * The contacts of the photocells are connected and open. * The stop contact is connected and open. * The edge contact is open. * Ammeter alarm. Check the jumpers or the connected devices and the signals indicated on the warning lamp. If the ammeter alarm has intervened, increase the torque parameter.
How to fix SEA Control Unit gate that doesn’t reach the complete Open / Closed position?
If the gate doesn’t reach the complete Open or Closed position, consider the following: 1. The limit switches might be set incorrectly: Set limit switches. 2. There may be an error in programming: Repeat programming. 3. An obstacle may be stopping the gate: Remove obstacle. 4. The torque might be too low: Increase the torque parameter.
What to do if SEA GATE 1 DG R1 motor doesn’t respond to any START impulse?
If the motor doesn’t respond to any START impulse: * Check the connections or the jumpers on the connections of the safety edge or of the stop and of the photocell if connected. * Check the connected N.C. contacts. * If the fuse is burnt, replace the burned fuse on the control unit.
Why SEA GATE 1 DG R1 Control Unit gate doesn’t move while the motor is running?
If the gate doesn’t move while the motor is running: * The motor might be in the released position: Re-lock the motor. * There might be an obstacle: Remove obstacle.
General| Brand | SEA |
|---|---|
| Model | GATE 1 DG R1 |
| Category | Control Unit |
| Language | English |
