EasyManua.ls Logo

SeaDoo 2002 GTX 4-TEC - Specifications - Engine and Cooling; Engine Specifications; Cooling System Specifications

SeaDoo 2002 GTX 4-TEC
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
84
Engine Lacks Acceleration or Power
Watercraft Can Not Reach Top Speed
Engine RPM Gradually Decreases and Engine Stops
OTHER OBSERVATION POSSIBLE CAUSE REMEDY
Engine oil level too high.
Refer to an authorized Sea-Doo
dealer.
Weak spark.
Refer to ENGINE MISFIRES, RUNS
IRREGULARLY.
The monitoring system put the
watercraft in limp home mode
due to a component
malfunction.
Refer to Monitoring System in
SPECIAL PROCEDURES.
Engine damaged by water
ingestion.
Refer to an authorized Sea-Doo
dealer.
Clogged injectors.
Refer to an authorized Sea-Doo
dealer.
Low fuel pressure.
Refer to an authorized Sea-Doo
dealer.
Water in fuel.
Siphon and replace.
OTHER OBSERVATION POSSIBLE CAUSE REMEDY
Cavitation.
Jet pump water intake clogged.
Clean.
Damaged impeller.
Replace. Refer to an authorized
Sea-Doo dealer.
The SEA-DOO Learning Key
TM
safety lanyard is used which
does not allow watercraft to
reach its top speed.
Use a regular safety lanyard.
The monitoring system put the
watercraft in limp home mode
due to a component
malfunction.
Refer to Monitoring System in
SPECIAL PROCEDURES.
O.P.A.S.
TM
side vanes
do not go up while
watercraft is at speed.
Clogged filter, square rings
damaged, leakage in hoses or
mechanical malfunction.
Refer to an authorized Sea-Doo
dealer.
O.P.A.S. side vanes
do not go down while
engine is at idle.
Broken spring inside side vane
cylinder.
Refer to an authorized Sea-Doo
dealer.
OTHER OBSERVATION POSSIBLE CAUSE REMEDY
Out of fuel
Refill.
CPS sensor malfunction.
Refer to an authorized Sea-Doo
dealer.
TOPS malfunction.
Refer to an authorized Sea-Doo
dealer.
smo2002-003_a.book Page 84 Friday, October 12, 2001 2:04 PM

Table of Contents

Related product manuals