Section 01 ENGINES (1503 4-TEC)
Subsection 07 (CYLINDER BLOCK)
– connecting rod screws
1
R1503motr08A
1. Connecting rod screws
NOTE: Before removing the connecting rod caps,
mark them to remember the right position when
reassembling. It is recommended to measure
connecting rod big end axial play prior to remove
connecting rod. Refer to PISTON/CONNECTING
ROD in this section for the procedure.
R1503motr07A
1
1. Mark on connecting rod
– thrust washers no. 4
R1503motr09A
1
1. Thrust washer
– crankshaft no. 5.
1
R1503motr10A
1. Crankshaft
Inspection
Replace crankshaft if the gears are worn or other-
wise damaged.
SMR2005-037 101
To Next Page
Loading...