Section 01 ENGINES (1503 4-TEC)
Subsection 03 (PTO HOUSING AND MAGNETO)
R1503motr15A
1
1
1
2
2
2
2
2
TYPICAL
1. Screws M6 x 35
2. Screws M6 x 85
Tightening sequence for screws on PTO housing
is as per following illustration.
R1503motr15B
1415
16
17
18
19
20
21
2 3 4
5
6
7
8
9
1011
1
1213
Reinstall LH engine support. Apply Loctite 243
(P/N 293 800 060) on screw threads then torque
to 24 N•m(17lbf•ft).
Remove block under engine.
Refill engine with oil and cooling system with
coolant. Refer to LUBRICATION and COOLING
SYSTEM sections of the appropriate VEHICLE
SHOP MANUAL.
PTO SEAL
Inspection
Check the PTO seal no. 22 and O-rings no. 10 on
the PTO housing. If brittle, hard or damaged, or if
you see a sign of oil leakage, replace it.
Removal
Place rags under PTO housing to prevent spillage.
If spillage occurs, clean immediately with the pul-
ley flange cleaner (P/N 413 711 809) to prevent oil
stains.
Remove:
– Oetiker clamp no. 11 located close to the PTO
housing
– PTO seal no. 22.
1
R1503motr47A
2
TYPICAL
1. Oetiker clamps
2. PTO seal
34 smr2005-032
To Next Page
Loading...