Section 01 ENGINES (1503 4-TEC)
Subsection 03 (PTO HOUSING AND MAGNETO)
1
R1503motr21A
2
3
TYPICAL
1. CPS screws
2. Holding plate
3. CPS
– screws no. 16
– stator no. 17.
1
R1503motr26A
2
TYPICAL
1. Stator screws
2. Stator
Installation
For installation, reverse the removal procedure.
However, pay attention to the following.
NOTE: There is only one position for the stator
(notch in the magneto housing cover).
1
R1503motr51A
TYPICAL
1. Notch for stator
Place the rubber grommets on both cables in the
proper notches at the PTO housing.
1
R1503motr52A
2
TYPICAL
1. Grommet on CPS cable
2. Grommet on stator cable
Apply Loctite 243 (P/N 293 800 060) on threads.
Torque stator and CPS screws to 10 N•m
(88 lbf•in).
ROTOR AND TRIGGER WHEEL
Removal
Lock crankshaft with locking tool (P/N 529 035
821). Refer to CYLINDER BLOCK section.
Remove:
– PTO housing
– hexagonal screws no. 18 retaining rotor.
36 smr2005-032
To Next Page
Loading...