Section 01 ENGINES (1503 4-TEC)
Subsection 04 (LUBRICATION SYSTEM)
1
R1503motr110A
TYPICAL
1. Oil cooler
Removal
Remove:
– cooling hoses no. 34 and no. 35
– retaining screws no. 36
– oil cooler no. 37
1
R1503motr147A
1
2
1. Screws
2. Oil cooler
– O-rings no. 38.
1
R1503motr148A
1. O-rings
Inspection
If O-rings are brittle, cracked or hard, replace
them.
Clean both contact surfaces of oil cooler.
Check and clean the oil inlet and outlet area for dirt
and other contaminations.
Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
Apply grease on O-rings.
Torque oil pump cover screws to 10 N•m
(89 lbf•in). Apply Loctite 243 (P/N 293 800
060) on threads.
SMR2005-035 59
To Next Page
Loading...