Seaflo SFBP1-G600-07 User Manual (English)

To Next Page

page

Multi Port Shower Sump Pump

Instruction Manual

SECURITY

The shower sump pump may not be used for other liquid than water/bilge water.

Always use the fuse required, see “Design features” below.

The wire connections must be sealed with a marine sealant.

Always install the pump with black lead negative (-) and brown/brown white lead positive (+).

All electrical wiring must be clamped with the connections well above the bilge water level. Do not remove

the insulation more than necessary. All wiring connections should be sealed with a marine sealant oxidation.

Do not run dry.

DESIGN FEATURES

Volt

(V)

12V

24V

12V

24V

Current

(A)

2.5A

1.5A

3.0A

1.6A

Wire Lead

(M)

SFBP1-G600-07

SFBP2-G600-07

SFBP1-G750-07

SFBP2-G750-07

Model

Flow Rate

(GPH)

600GPH

750GPH

Head

(M)

2.5

3 .0

N.W/G.W

(kg)

1.17/1.35

1.17/1.36

1.17/1.37

1.17/1.38

MOUNTING INSTRUCTIONS

Fasten the shower sump pump to the hull by screws in the four mounting holes.

Need help?

Do you have a question about the Seaflo SFBP1-G600-07 and is the answer not in the manual?

Seaflo SFBP1-G600-07 Specifications

General

Model	SFBP1-G600-07
Category	Water Pump
Voltage	12V DC
Flow Rate	600 GPH
Housing Material	Thermoplastic
Fuse Size	5A
Outlet Diameter	3/4" (19mm)
Wire Lead	1 meter
Current	2.5 A
Max Flow Rate	600 GPH
Inlet/Outlet Size	3/4"
Operating Temperature	0°C to 43°C
Current Draw	2.5 Amps