Seagate FireCuda 520 - Installation Guide; Installing the FireCuda 520 SSD

Installaon
Install FireCuda 520 SSD
1. Before installing FireCuda 520 SSD, power down your computer and unplug any cables attached to it.
2. Open the case or cabinet.
3. If an existing SSD drive is installed in the M.2 PCIe slot you intend to use for FireCuda 520 SSD, you'll
need to remove it.
4. Power on your computer.
5. Access the BIOS setup while the computer is booting. Ensure that a PCIe device is set in the BIOS boot
sequence or boot priority list.
6. Power down the computer and locate the M.2 PCIe slot on your motherboard.
Note—Some motherboards have a pad installed in the M.2_PAD space by default.
This pad can be removed to ensure a better fit for FireCuda SSD.