Seagate One Touch SRD0VN2 - Getting Started; Connect the USB cable; Set up One Touch

Geng Started
Connect the USB cable
Use the Micro-B to USB-A cable to connect One Touch to a computer’s USB-A port.
Set up One Touch
The setup process lets you:
Register Seagate One Touch Get the most from your drive with easy access to information
and support.
You can connect your Seagate device to a USB-C port on your computer. The USB-C port must
support USB 3.0 or higher. A USB micro-B to USB-C cable is not included with this device.
