QUICK START UP
Simply begin exercising. The console will automatically begin counting up and
tracking your information.
RESET
Press and hold the select button on the console.
123 301340
11
PROBLEM: Erratic or Inconsistent Readout.
SOLUTION: Check your exercise environment for sources of interference such
as high power lines, large motors, etc.
You may experience an erratic readout under the following conditions:
- Gripping the heart rate handlebars too tight. Try to maintain moderate pressure
while holding onto the heart rate handlebars.
- Constant movement and vibration due to constantly holding the heart rate grips
while exercising.
- When you are breathing heavily during a workout.
- When your hands are constricted by wearing a ring.
- When your hands are dry or cold. Try moistening your palms or rubbing them
together to warm.
- Anyone with heavy arrhythmia.
- Anyone with arteriosclerosis or peripheral circulation disorder.
- Anyone whose skin on the measuring palms is especially thick.
Note: Outside interference sources such as computers, motors and fluorescent
lights may cause the heart rate reading to be erratic.
If the above troubleshooting section does not remedy the problem,
discontinue use and turn the power off.
DO NOT RETURN TO THE STORE, PLEASE CONTACT THE
SEARS CUSTOMER ASSISTANCE CENTER;
TOLLFREE @ 1-888-993-3199.
mph/km CONVERSION
The speed readout on the console automatically defaults to mph when installing
the batteries. To convert the speed readout to kilometers, press and hold the
‘Select’ button for three seconds. At this time, the time display should register
0:00. Continue to press the ‘Select’ button for an additional 2 seconds until the
time display registers 0:00 once again. The console should now be set for km.
To switch back to mph, simply remove the batteries in the console.
HEART RATE TROUBLESHOOTING
To Next Page
Loading...
