Seashell SS-1 - Installing the Dove Tail Shims & Actuator Shafts

Page 18
Page 17
Preparation of the Seashell
Loading the Camera into the Seashell
Storage
Photographing
Specifications
•
•
•
•
•
•
•
•
•
Fasten both ends of the Neck Strap or the
Hand Strip to the Strap Mounts of Seashell.
Use of the Neck strap underwater is dangerou
s
as the Neck Strap may be entangled and
cause strangulation or other mishap.
Apply an anti
-
condensation solution to the
inside face of the lens window if required.
Do not use too much.
Inspect the o
-
ring of the Seashell to ensure
sufficient grease is present, but without dirt
or sand. If necessary, apply grease to the
o
-
ring as instructed in the section,
“Maintenance of the O
-
Ring”.
Close the Seashell by pressing the front and
rear housings together and flip the lock with
your first fingers.
Store the Seashell camera housing in a
clean, cool and dry place away from direct
sunlight.
Store the Seashell camera housing away
from strong solvents or other chemicals.
Keep the Seashell housing open during
extended storage.
Press the power button to turn the camera
“On”.
Use the shutter to snap pictures.
Materials: Predominantly polycarbonate,
glass and silicone
Operating Temperature: 32 to 104 F (0 to 40 C
)
Maximum water depth:
131 ft (40 m)
Weight:
12 oz (housing only)
Subject to change without any notice,
International Patents Pending.
Copyright 2010 Zear Corporation Limited
Seashell is a registered trademark of Zear
Corporation Limited