Autopilot Pump
19
3.3.1
Twin Station Single Cylinder
Perform Steps 3.1.1 – 3.1.6 at
station no. 1. Then repeat Steps
3.1.2 – 3.1.5 at station no. 2.
Note: Refer to Oil Level & System
Check on page 20.
Step 3.3 Additional Purge Instructions
STATION NO.2
STATION NO.1
CYLINDER
AP UNIT
3.3.3
Twin Station Twin Cylinder
Follow same procedure as
instructed for single station-
twin cylinders, beginning at
station no. 1, and repeat entire
procedure at station no. 2.
Note: Refer to Oil Level & System
Check on page 20.
3.3.2
Single Station Twin Cylinder
When performing Steps 3.1.1 –
3.1.6, perform instructions in
each step first on cylinder no. 1
and then on cylinder no. 2,
before proceeding to the next
step. ie: Perform instructions
referring to right side of
cylinder first on cylinder no. 1
and then on cylinder no. 2.
Note: Refer to Oil Level & System
Check on page 20.
CYLINDER NO.2
CYLINDER NO.1
AP UNIT
CYLINDER NO.2
CYLINDER NO.1
STATION NO.2
STATION NO.1
AP UNIT
AUTOPILOT PUMP
To Next Page
Loading...
