12
SEASTAR Hydraulics
Connect the Red (+) and Black (-) wires of the Autopilot pump to
t
he controller as per the Autopilot manufacturers recommendations.
The polarity may need to be reversed on some controllers in order to
operate correctly.
When extending wire leads, marine best practices must be followed.
Solder and shrink wrap are highly recommended. Appropriately
sized and properly installed crimp connections with shrink wrap
protection are also acceptable. A MIN of 12AWG wiring should be
used for any extensions.
Lead wires should be kept as short as possible.
Step 2 Autopilot Electrical Connections
Refer to the Autopilot controller manufacturer for EMC wire guidelines,
installation manuals and ALL notices, cautions and warnings.
NOTICE
ONLY use approved electrical connectors or junction boxes with
the correct power rating.
WARNING
If installing in an area where fumes from fuel are present, be sure to
completely vent this area prior to making ANY electrical connections.
Failure to do so may result in an explosion and/or fire causing
property damage, personal injury and/or death.
WARNING
AUTOPILOT PUMP
To Next Page
Loading...
