If and when218
After changing a wheel
After changing the wheel there are still tasks to complete.
– Put the tools and jack back in the luggage compartment.
– Place the wheel with the defective tyre in the luggage compart-
ment and secure it.
– Check the tyre pressure of the newly fitted tyre as soon as
possible.
– Have the tightening torque of the wheel bolts checked as soon as
possible with a torque wrench. The prescribed torque is 120 Nm.
Note
• If you notice that the wheel bolts are corroded and difficult to turn when
changing a wheel, they must be replaced before having the wheel bolt torque
checked.
• In the interest of safety, drive at moderate speeds until the wheel bolt
torque has been checked.
Wheel trims
The wheel trims must be removed to gain access to the wheel
bolts.
Removing
– Insert the extraction hook from the tool kit into the hole
designed for this and that is situated in one of the bolt caps of
the hubcap ⇒ fig. 147.
–Pull off the wheel cover.
Fig. 147 Changing a
wheel: Removing the
wheel trim
s1cg.2.book Seite 218 Montag, 25. April 2005 3:54 15
To Next Page
Loading...
