Seat Leon 5D - Page 147

Transport and practical equipment
●
Close the rear lid.
Closing the tailboard
●
Lift the tailboard cover until it engages. The
red mark on the luggage compartment side
should never be visible.
●
Close the rear lid.
●
Lift the centre armrest if necessary.
Note
The tailboard can also be opened from the
luggage compartment. To do so, press the
release lever down, in the direction of the
arrow, and the cover upwards
›››
Fig. 137.
Net partition*
Using the separation net behind
the rear seat*
3 Valid for: LEON Sportstourer
Fig. 138
In the luggage compartment: secur-
ing the net partition.
Fig. 139
In the luggage compartment: remov-
ing the net partition.
Pulling out and securing the net partition
●
Pull up handle
›››
Fig. 138
2
to remove the
net from the casing
4
.
●
Hook in the net partition on the right or left
side
3
(magnified image).
●
Hook in the net partition into the housing on
the other side
1
by pulling the rod.
The net partition is properly assembled when
the T-shaped ends are firmly secured in the
corresponding housings
3
and
1
.
Retracting the net partition
●
Unhook the rod from the housings
3
and
1
.
●
Roll up the net into the casing
4
lowering it
with your hand.
Removing the net partition
●
Fold the rear seat backrests forward.
●
Press the left or right release catch
›››
Fig. 139 in the direction of the arrow
1
.
●
Remove the casing from the support in the
direction of the arrow
›››
Fig. 139
2
.
Fitting the net partition
●
Fold the rear seat backrests forward.
●
Fit the casing in the right and left supports.
●
Press the casing into the left and right sup-
ports in the opposite direction to the arrow
›››
Fig. 139
2
until it engages.
»
145