EasyManua.ls Logo

Seat Leon - Page 276

Seat Leon
356 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Driving
Parallel parking
Fig. 192 Display on the Infotainment system
scr
een.: parking with r
e
verse assist.
Key to the Fig. 192:
Finding a parking space
Go t
o the sel
ect
ed parking space
Centre the vehicle inside the parking
space
Road
Parking space
Lateral boundary of the parking space
Rear boundary of the parking space
1
2
3
4
Parking
In the infotainment system select > Driv-
er assist
ance> P
arking aid
before passing in
front of the selected parking space.
With reverse assist connected and in work-
ing order, press the function button .
Place the vehicle in front of the parking
space
››
Fig. 192
2
.
Reverse while turning the steering wheel so
that the yell
o
w lines ent
er the parking space.
The green and yellow lines must match the
side boundary lines
3
.
Stop the vehicle when the red line has
r
eached the r
ear boundary
4
.
Problems and solutions
The system behaves differently than ex-
pect
ed
Ther
e can be se
veral causes:
The camera is dirty
››
page 322. In addi-
tion to dirt and snow, camera visibility can be
reduced by detergent residue or any type of
coating.
The system requirements must be met
››
page 273.
The camera is covered with water.
The factory-fitted towing bracket must not
be electrically connected to a trailer
››
page 282.
The vehicle has some type of damage in
the camera area, e.g. due to a parking im-
pact.
The field of view of the camera is blocked
by an accessory, e.g. a bicycle carrier sys-
tem.
Changes have been made to the paint in
the camera area, or structural modifications
have been made to a component such as the
running gear.
Camera with no visibility, fault message,
the system disconnects
Clean the camera or remove possible ad-
hesives or accessories from it
››
page 322.
Check for visible damage.
Possible solution
Temporarily disconnect the system.
Check if one of the causes indicated above
has occurred.
Once the source of the problem has been
eliminated, the system may be reconnected.
If the system still behaves unpredictably,
have it checked by a specialised workshop.
274

Table of Contents

Related product manuals