4
SEBO ET POWER HEAD PRODUCT FEATURES
Your SEBO ET-1 and ET-2 Power Heads are designed for use with SEBO canister vacuum cleaners and central
vacuum units. Please note: The on/off foot switch is not available on some models.
The SEBO ET-1 (12 inches wide, 10
1⁄2-inch cleaning path) and ET-2 (14
3⁄4 inches wide, 13-inch cleaning
path) – This model comes in two
widths and has four-level manual
brush height adjustment. It aggres-
sively cleans carpets, but the brush
roller may be switched off by pressing
the green illuminated on/off switch on the power
head, or the switch located on the handle, so delicate
rugs and hard floors can be cleaned with straight
suction. Its amazing 180° steering ability provides
maneuverability around furniture, and the extension
side of the L-shaped head makes cleaning edges and
under counters easy.
Brush Obstruction Light & Auto Shut
Off – If an obstruction be-comes
jammed in the brush roller, a red
brush-warning light will quickly flash,
the brush roller will immediately stop
spinning and the vacuum will shut off.
The user should turn the power switch off, unplug the
machine, and immediately remove the obstruction. If
the user restarts the machine without removing the
obstruction, the power head will again shut off and the
red light will flash.
This prevents the belt from break-
ing and protects the motor and carpet from damage.
Incorrect Height Setting or Brush
Deterioration Light – To ensure opti-
mum cleaning at all times, a red
brush-warning light will illuminate, to
indicate when the brush height is set
too high for effective cleaning or when
the brush roller should be replaced due to excessive
wear.
Manual Height Adjustment - The ET power head brush
height may be adjusted for high carpet (dial setting 4)
and progressively lower to bare floor (dial setting 1). The
brush-warning light located on top of the power head
will illuminate red if the height setting is too high or if the
brush roller is worn. Dial down to the next number until
the red light turns off.
Manual and Automatic Brush Shut
Off – The ET power head can clean
delicate rugs or hard floors with
straight suction because the brush
roller can be manually switched off
by pressing the green illuminated
on/off switch on power heads
equipped with the foot switch. On
power heads without the foot
switch, the brush roller can be
switched off on the handle. Also,
the brush roller automatically
shuts off when the suction hose
from an attached vacuum is
removed from its housing port or
when the swivel neck of the power head is in its
upright-locked position.
Stationary Use - When the power head swivel neck is
in the upright-locked position, it is designed to shut
off the brush roller. The on/off light* illuminates yel-
low when in the upright locked position. The green
light will illuminate only in the operating position. An
operating power head should not stand stationary on
the floor for inappropriate periods of time.
Easy Brush Removal and Cleaning – Cleaning hair or
other debris from the brush roller
or replacing it when its bristles are
worn is quick and easy, and no
tools are required! This feature
ensures consistently effective
brush agitation of the carpet pile.
Easy Maintenance – The clog removal door and
brush roller are easy to access on the power head.
CENTRAL VAC WAND
The optional SEBO Central Vac Wand, part
#6272CA, fits on SEBO ET-1 and ET-2 power
heads and can attach to most existing central
vacuum handle/hose units. The telescopic wand
can be adjusted from 24” to 37” in length to acco-
modate the correct operating height for individ-
ual users.
The wand is made of stainless steel and high-
quality plastic that is durable and reliable.
To Next Page
Loading...
